Cisco Catalyst 2950 Hardware Installation Guide

Chapter 3 Installation
Preparing for Installation
3-4
Catalyst 2950 Desktop Switch Hardware Installation Guide
78-11157-05
Warning Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Warning Ultimate disposal of this product should be handled according to all national
laws and regulations.
Warning Attach only the Cisco RPS (model PWR300-AC-RPS-N1) to the RPS receptacle.
Warning Invisible laser radiation may be emitted from disconnected fibers or
connectors. Do not stare into beams or view directly with optical instruments.
Warning Class 1 laser product
Warning Avoid direct exposure to the laser beam
EMC Regulatory Statements
This section includes specific regulatory statements about the Catalyst 2950
switches.
U.S.A.
U.S. regulatory information for this product is in the front matter of this manual.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz