CHAPTER 14
Getting Started with Your New ATA
It’s easy to get started with your new Cisco ATA. It adds various call features to any device you attach to it,
such as an analog phone or fax machine. You install the ATA, perform the initial setup in Cisco Webex, and
activate it.
• Your New ATA, on page 49
• Devices Associated with Your ATA, on page 50
• Install Your New ATA, on page 50
• Complete Your Initial Setup in Cisco Webex Settings, on page 51
• Get an Activation Code, on page 51
• Activate Your ATA, on page 52
• Supported ATA Call Features, on page 53
Your New ATA
Your analog telephone adapter (ATA) allows you to connect an analog device, such as an analog phone or
fax machine, to your network. The connected device can then function like the IP phones in your network.
Your new analog telephone adapter (ATA) has two interfaces:
• A RJ11 port for an analog device
• A RJ45 port for Ethernet
Light-emitting diodes (LEDs) on the ATA provide status.
You'll perform these tasks:
• Install your ATA with the components in the box.
• Sign in to Cisco Webex Settings and complete your initial setup.
• Activate your analog device.
• If you need to reset your device, ask your administrator to use Cisco Webex Control Hub to do so. Do
not use the RESET button on the back of your ATA unless your administrator tells you to.
Cisco IP Phone 7800 and 8800 Series, Cisco IP Conference Phone 7832, and Cisco ATA 190-SC User Guide for Webex Calling (formerly Spark
Call)
49
To Next Page
Loading...
