EasyManua.ls Logo

Cisco Mesh Access Points - Page 148

Cisco Mesh Access Points
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
You do not need to configure VLAN tagging to use Ethernet bridging for point-to-point and
point-to-multipoint bridging deployments.
Note
2
When you want to connect any Ethernet device such as a video camera on the MAP using its Ethernet
port. This is the first step to enable VLAN tagging.
Figure 59: Point-to-Multipoint Bridging
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
132 OL-27593-01
Connecting the Cisco 1500 Series Mesh Access Points to the Network
Configuring Local Mesh Parameters

Table of Contents

Related product manuals