EasyManua.ls Logo

Cisco Mesh Access Points - Link Test Result

Cisco Mesh Access Points
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Link Test Result
Figure 74: Link Test Results
A link test can also be run from the controller CLI using the following command:
(Cisco Controller) > linktest client mac-address
Link tests from the controller are only limited to the WGB, and they cannot be run beyond the WGB from
the controller to a wired or wireless client connected to the WGB. You can run link tests for the wireless client
connected to the WGB from the WGB itself using the following command:
ap#dot11 dot11Radio 0 linktest target client-mac-address
Start linktest to 0040.96b8.d462, 100 512 byte packets
ap#
RetriesSNR QualityStrength (dBm)Time (msec)POOR (4% lost)
OutInOutInOutIn
35Tot. 34348-83-37Avg. 22Sent: 100
5Max. 101061-78-34Max. 112Lost to Tgt: 4
315-87-40Min. 0Lost to Src: 4
Rates (Src/Tgt) 24Mb 0/5 36Mb 25/0 48Mb 73/0 54Mb 2/91
Linktest Done in 24.464 msec
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
166 OL-27593-01
Connecting the Cisco 1500 Series Mesh Access Points to the Network
Workgroup Bridge Interoperability with Mesh Infrastructure

Table of Contents

Related product manuals