Mesh Access Point Debug Commands
You can enter these commands directly on the mesh access point using the AP console port or you can use
the remote debug feature from the controller.
• debug mesh ethernet bridging—Debugs Ethernet bridging.
• debug mesh ethernet config—Debugs access and trunk port configuration associated with VLAN
tagging.
• debug mesh ethernet registration—Debugs the VLAN registration protocol. This command is associated
with VLAN tagging.
• debug mesh forwarding table—Debugs the forwarding table containing bridge groups.
• debugs mesh forwarding packet bridge-group—Debugs the bridge group configuration.
Defining Mesh Access Point Roles
By default, the AP1500s are shipped with a radio role set to MAP. Therefore, you must change the radio role
on a mesh access point for it to function as RAP.
You can change this configuration on the mesh access point by statically setting them as rooftop access points
or mesh access points with the config ap role {rootAP | mesh AP | default} command:
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
OL-27593-01 213
Troubleshooting
Mesh Access Point Debug Commands
To Next Page
Loading...
Need help?
General
