The modem command is any command or text to send to the cable modem. The range of timeout value is 1
to 300 seconds. However, if the captured data equals 9600 characters, any text beyond that is truncated and
the response, irrespective of the timeout value and is immediately displayed on the AP console.
Figure 85: Cable Modem Console Access Command
Figure 86: Cable Modem Console Access Command
Cisco Mesh Access Points, Design and Deployment Guide, Release 7.3
OL-27593-01 211
Troubleshooting
Cable Modem Serial Port Access From an AP
To Next Page
Loading...
Need help?
General
