Using Cisco QuickVPN for Windows 2000, XP, or Vista
Using the Cisco QuickVPN Software
Cisco RVS4000 Security Router with VPN Administrator Guide 138
B
The QuickVPN Login window appears.
STEP 2 Enter the following information:
• Profile Name: Enter a name for your profile.
• User Name and Password: Enter the user name and password that were
assigned to you.
• Server Address: Enter the IP address or domain name of the VPN router.
• Port for QuickVPN: Enter the port number that the QuickVPN client will use
to communicate with the remote VPN router, or keep the default setting,
Auto.
QuickVPN Login
STEP 3 To save this profile, click Save. (If there are multiple sites to which you will need to
create a tunnel, you can create multiple profiles, but note that only one tunnel can
be active at a time.) To delete this profile, click Delete. For information, click Help.
STEP 4 To begin your QuickVPN connection, click Connect. The connection’s progress is
displayed: Connecting, Provisioning, Activating Policy, and Verifying Network.
If a user certificate is not pre-installed on the PC, a pop-up warning appears. Click
OK to acknowledge the message.
STEP 5 When your QuickVPN connection is established, the QuickVPN tray icon turns
green, and the QuickVPN Status window appears. The window displays the IP
address of the remote end of the VPN tunnel, the time and date the VPN tunnel
began, and the total length of time the VPN tunnel has been active.
To Next Page
Loading...
Need help?
General
