Setting Up and Configuring the Router
Firewall
Cisco RVS4000 Security Router with VPN Administrator Guide 50
5
Source Interface Select the source interface, WAN, LAN, or ANY, from the drop-
down menu.
Source IP To apply the rule to one source IP address, select Single from the drop-
down menu, then enter the address in the field. To apply the rule to all source IP
addresses, select ANY from the drop-down menu. To apply the rule to a range of
IP addresses, select Range and enter the starting and ending IP addresses. To
apply the rule to a subnet, select Net and enter the IP address and subnet mask.
Destination IP To apply the rule to one destination IP address, select Single from
the drop-down menu, then enter the address in the field. To apply the rule to all
destination IP addresses, select ANY from the drop-down menu. To apply the rule
to a range of IP addresses, select Range and enter the starting and ending IP
addresses. To apply the rule to a subnet, select Net and enter the IP address and
subnet mask.
Days To make the rule apply on a daily basis, select Everyday. To make the rule
apply on specific days of the week only, select the desired days.
Time To make the rule apply for an entire day, select 24 Hours. To make the rule
apply only during a specific period of the day, enter the starting time in the From
field and the ending time in the To field.
Click Save to save your changes, or click Cancel to undo your changes. Click
Return to return to the IP-Based ACL window.
To Next Page
Loading...
Need help?
General
