ClearCom FreeSpeak II - Selecting Beltpack Role Default Set; Selecting Beltpack Administration

User Guide | FreeSpeak II™ Base station version
Page 110
 Vibrate
 Audio warning and vibrate
 Off
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Settings > Alarm
Options > Call Alert Mode.
3) Use either rotary control to select between:
 Vibrate & Audio (default)
 Vibrate Only
 Audio Only
 Off
4) To confirm the selection and exit the menu screen, press the Menu
Select key (D).
8.7 Selecting the beltpack role default set
Use this setting to set the beltpack configuration to the default settings
downloaded from the configuration editor.
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Settings > Role Default
Set.
3) Use either rotary control to select between:
 On (default)
 Off
4) To confirm the selection and exit the menu screen, press the Menu
Select key (D).
8.8 Selecting the beltpack administration
You can select the following administration settings:
 System pairing mode
 Full menu access