ClearCom FreeSpeak II - Accessing Beltpack Information; Setting Display Mode; Setting System Connect

User Guide | FreeSpeak II™ Base station version
Page 113
8.10 Accessing beltpack information
You can access a list of beltpack information, including battery and fault-finding
information.
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Information.
You can read the following information:
Item
Value
Beltpack role
Role name
SW (software)
Version number
Beltpack. ID (beltpack identity)
ID number
RFP (Remote Fixed Part –
antenna/receiver)
ID number
Regional (radio frequency area)
Radio frequency region.
Battery Level
Percentage charge, hours of use
Table 18 Beltpack information
8.11 Setting display mode
You can select between two display modes: Intercom mode and Partyline mode.
Note: You can only access this option if you have advanced menu access.
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Display Mode.
3) Use either rotary control to select between:
 Intercom mode
 Partyline mode
8.12 Setting system connect
Use this option to connect to an antenna.
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select System Connect.