ClearCom FreeSpeak II - Beltpack Menu Maps

User Guide | FreeSpeak II™ Base station version
Page 173
12.2 Beltpack menu maps
Note: Beltpack menus can be accessed by pressing and holding the menu button on the device (3 second press).
FreeSpeak II beltpacks can display different menus, allowing configuration rights according to your need and work
context.
When a beltpack is not connected to any systems, it will display an Offline menu. Once a beltpack is connected to a
matrix or Base station, menu access can be set in the system configuration software (EHX or FreeSpeak Configuration
Editor). There are four menu options available in the configuration software:
 Basic
Basic menu options allow:
o Local beltpack volume control
o Information relating to device
 Normal
Normal menu options allow:
o Local beltpack volume control
o Local settings (for instance, headset detect, sidetone, mic echo cancellation, listen again options)
o The ability to connect the beltpack to a system using the admin pin code.
 Advanced (see table below for details)
In addition to the normal functions, the advanced menu options offers:
o Volume operation. This allows the beltpack user to change how the device’s overall volume settings
operate (Toggle Talk Key/Master Volume)
o Display mode. This allows the user to change the beltpack display (Toggle Partyline/Intercom display)