User Guide | FreeSpeak II™ Base station version
o Site survey. This gives access to information on local transceiver/antennas and their performance.
None.
Note: From each menu, you can enable advanced menu options if you have the admin pin code. The default value for this is
4632.
There is also a Standalone or rigging menu which can be used when surveying a site without connecting to a matrix
or Base station. To access the Standalone menu see 3.4.6 Surveying a site in standalone (rigging) mode.
When beltpacks are connected to a matrix or Base station, the beltpacks will take their menu settings from the current
configuration map in the Configuration Editor. However, using the admin pin code to obtain access, you can reset the
menu settings on the beltpack from Basic or Normal to Advanced. The default admin pin code is 4632. This is a
temporary measure, and the menu setting from the configuration map will reset if the beltpack is recycled (switched
off and on).
See below for details of the advanced menu options. The other menus are subsets of this menu.
Advanced menu rights
(available in
advanced
options only)
To Next Page
Loading...
