User Guide | FreeSpeak II™ Base station version
1) From the Name list, select the beltpack.
2) Click on the down arrow beside each window to open a drop-down menu
of all the available ports or key types and select the required item. The
selected item will appear in the window.
Note: If the key assignment is ‘----’ then the beltpack key is locked and
cannot be used.
For an explanation of the available port types abbreviations see Table 19
Available port types.
Front panel headset on channel A
Front panel headset on channel B
4WIR1, 4WIR2, 4WIR3, 4WIR4
Four Base station 4-wire output ports
One of up to twenty beltpacks
One of up to five configured groups
One of up to five wireless partylines
One of up to 10 interruptible foldbacks
Table 19 Available port types
Use the Copy and Paste buttons to copy the setup of the current beltpack and
paste that setup onto another beltpack. This allows you to quickly configure
beltpacks when many have the same setup.
Use the Clear button to clear all key assignments for the current beltpack.
10.4.9 Configuring the Reply key
You can configure the Reply key in the following ways:
As a Reply key. You can reply to the call by pushing the REPLY key (this
is the default setting for this key).
Assigning a talk/listen destination. Pushing the Reply key calls this
destination. For example, if you select STGAN from the list, the label
STGAN appears in the display. You can always activate the stage
announce by pushing the REPLY key. The key type will be enabled
allowing the reply key to be configured.
To Next Page
Loading...
