User Guide | FreeSpeak II™ Base station version
Figure 3-6 Using an antenna and beltpack in standalone mode
3.5 Registering beltpacks
Before you can use a beltpack, you must first register it with the FreeSpeak II
system.
You can register the beltpacks using a USB cable or over the air (OTA).
For USB cable registration, use:
o The FS II configuration editor (see 10.4.2 Registering beltpacks
using the micro USB cable to register the beltpack to the Base
station.
For Over the air (OTA) registration, use:
o The FS II Base station (see below)
o The FreeSpeak Configuration Editor (10.3 Registering beltpacks
using the over the air (OTA) facility.)
To Next Page
Loading...
