ClearCom FreeSpeak II - Beltpack Rear Panel; Using the Beltpack; Registering the Beltpack

User Guide | FreeSpeak II™ Base station version
Page 94
7.2.6 Beltpack rear panel
Figure 7-7 Beltpack rear panel
Key to beltpack rear panel
Feature
Description
A
Beltpack clip
B
Beltpack battery compartment
Table 17 Key to beltpack rear panel
7.3 Using the beltpack
7.3.1 Registering the beltpack
Before you can use a beltpack, you must first register it with the FreeSpeak II
system. For more information, see 3.4.6 Surveying a site in standalone (rigging)
mode
You might need to scope a site (check the range and performance of an antenna)
without connecting to a Base station. To do this, a beltpack and antenna can be
put into standalone or rigging mode.