User Guide | FreeSpeak II™ Base station version
From the Listen Again Auto Delete list, select a timeout period. The
settings run from Off to 240 minutes. The factory default is 240 minutes.
Setting the listen again recording time
You can configure the beltpack to automatically record incoming audio to allow
you to replay the audio. To determine the recording period:
From the Listen Again Record Time, select a recording time. The
settings run from 0 seconds to 15 seconds. The factory default is 15
seconds.
Setting the Reply Tally Auto Clear time
You can configure the beltpack to automatically clear the reply tally.
From the Reply Tally Auto Clear list, select a time. The settings run
from Off to 60 seconds. The factory default is 10 seconds.
Menu Level
Use this option to determine what menu options are available to beltpack users.
From the Menu list, select from the following settings:
Advanced- all menu options are available.
Normal – all menu options are available except:
o Main > Volume Operation
o Main > Display Mode
o Main > Settings > Headset Options > Headset Limiter
Basic – all menu options are available except:
o Main > Volume Level Control
o Main > Line In Volume Level
o Main > Admin Options
o Main > System Connect
o Main > Information
None – no menu options are available except:
Main > Admin Options (admin code required)
The factory default is Normal.
Enabling key latching
Key latching determines whether the beltpack keys latch when pressed so that
you do not have to keep the key pressed to maintain an audio route. If latching is
To Next Page
Loading...
