User Guide | FreeSpeak II™ Base station version
8.6.1 Setting the low battery alarm .................................................... 108
8.6.2 Setting the low battery alarm threshold ....................................... 109
8.6.3 Setting the out of range alarm ................................................... 109
8.6.4 Setting the call alert ................................................................. 109
8.7 Selecting the beltpack role default set ..................................... 110
8.8 Selecting the beltpack administration ...................................... 110
8.8.1 Enabling OTA registration mode ................................................. 111
8.8.2 Setting full menu access ........................................................... 111
8.8.3 Setting system sync mode ......................................................... 112
8.9 Setting the listen again option ................................................ 112
8.10 Accessing beltpack information ............................................... 113
8.11 Setting display mode ............................................................ 113
8.12 Setting system connect ......................................................... 113
8.13 Enabling over the air (OTA) registration mode from a beltpack .... 114
8.14 Performing a site survey ........................................................ 114
9 Operating the transceiver/antenna ................................... 116
9.1 Transceiver/antenna ............................................................. 116
9.1.1 IP rating (International Protection Marking) ................................. 116
9.1.2 FS II transceiver/antenna connector panel ................................... 117
9.1.3 Cabling the antennas ................................................................ 118
9.1.4 Beltpack support capacities for transceiver/antennas ..................... 118
9.1.5 Coverage areas under various conditions ..................................... 119
9.1.6 Transceiver/antenna setup rules and tips ..................................... 119
9.1.7 Upgrading the antenna/transceiver firmware ................................ 120
9.2 Transceiver/antenna splitter (PD2203) .................................... 121
9.2.1 PD2203 Front connector panel ................................................... 121
9.2.2 PD2203 rear panel ................................................................... 122
9.2.3 Connecting an antenna splitter to the FS II Base station and to
transceiver/antennas ................................................................ 123
10
FS II Configuration Editor
................................................. 124
10.1 Loading configurations .......................................................... 125
10.1.1 Loading a local configuration file ................................................ 125
To Next Page
Loading...
