InteliDrive DCU Industrial 3.4.0 Global Guide
27
3 Application overview
3.1 ID-DCU Industrial 27
6 back to Table of contents
3.1 ID-DCU Industrial
3.1.1 Default archives
The ID-DCU Industrial controller can be configured for auxiliary, emergency, combined (constant speed
engines) or propulsion mode engines. The configuration can be changed in the DriveConfig software by
selecting appropriate archive file.
Application Archive file Available modes Engine start / stop
SS
Single
Speed
ID-DCU
Industrial-SS-
3.4.0.aid
OFF - RUN
BI Blackout Start
BI Remote Start
BI Remote Stop
BI Rem Start/Stop
ID-DCU IndustrialStart / Stop
button
AS All Speed
ID-DCU
Industrial-AS-
3.4.0.aid
OFF - RUN
BI Blackout Start
BI Remote Start
BI Remote Stop
BI Rem Start/Stop
ID-DCU IndustrialStart / Stop
button
3.1.2 Operational modes
LOC (Local) mode
LOC (Local) mode can be set in any mode mentioned above – AUX, EME, HRB, PRP. ID-DCU Industrial
receives only commands entered from the ID-DCU Industrial front panel in LOC (Local) mode. All external
interfaces – binary inputs Remote Start, Blackout Start, RemRepStart, Remote Stop, Rem Start/Stop and
serial line commands are disabled.
LOC (Local) mode is activated and deactivated using ID-DCU Industrial front panel buttons: Enter + Mode→ to
activate, Enter + ←Mode to deactivate. Active LOC (Local) mode is indicated in the upper right corner of the ID-
DCU Industrial display.
OFF mode
All ID-DCU Industrial controller is switched off. Engine can’t be started or running engine is stopped,
prelubrication function is not active. Firmware and controller configuration can be changed in OFF mode only.