ComAp InteliDrive DCU Industrial - Analog Outputs Software Configuration

InteliDrive DCU Industrial 3.4.0 Global Guide
59
AI5 to AI8
Analog input
jumper = 2-3
(voltage)
0 - 1V / 10,000
AI5 to AI8
0 - 100mV / 100,00
AI1 to AI4
AI5 to AI8
Analog input
jumper = 3-4
(resistance)
0 - 1200 Ω / 100
Note:
It is possible to set up to 30 points non-linear sensor characteristics.
Connect external resistors (voltage divider) to extend input voltage range.
4.3.11 Analog outputs software configuration
Configuration
Image 4.5 Unconfigured analog output properties