ComAp InteliDrive DCU Industrial - Inteli IO8;8 (I-IO8;8)

InteliDrive DCU Industrial 3.4.0 Global Guide
297
8.2.3 Inteli IO8/8 (I-IO8/8)
Description
Inteli IO8/8 module is an extension module equipped with binary inputs, binary outputs and analog outputs.
The module can be used for ID-DCU, InteliMains-NT, InteliGen-NT and InteliSys-NT controllers.
“Inteli IO8/8” is the name of the module, but it is possible to configure the module (by internal switch) to two
configurations:
Inteli IO8/8 (8 binary inputs, 8 binary outputs and 2 analog outputs)
Inteli IO16/0 (16 binary inputs, 0 binary outputs and 2 analog outputs)
This module is compatible with MTU ECU-7 at communication speed 125 kbps when uploaded with firmware
1.1.0 and higher.
The detection of communication speed is indicated by fast flashing of status LED. Once the speed is detected
the module remains set for the speed even when the communication is lost. Renewal of communication speed
detection is done by reset of the module.
Available inputs/outputs
Binary inputs
8 channels
Can be configured as:
Pull up
Pull down
All 8 inputs are configured to one type together.