InteliDrive DCU Industrial 3.4.0 Global Guide
64
10
Cooling - Engine is switched to cooling state after the stop button is pressed, unloading process
finished.
11
Cooling - Engine is switched to cooling state after the stop button is pressed, unloading process
finished.
12 Shutdown - Any 2nd level alarm is active.
13 Ventil - Activation of ventilation, if gas engine was unsuccessful in starting.
14 EmergMan - Emergency manual is active.
15 Cooldown - 2nd level alarm cooldown is active.
16 LoadShar - Controller is in load sharing mode.
5.1.3 Protections
Brief description of the controller's protection - basic settings and use cases.
Note: There are visible only the first two bar graph marks for protection limits indication on ID-DCU Industrial
screen !!!
To Next Page
Loading...
