InteliDrive DCU Industrial 3.4.0 Global Guide
317
Power supply 8 to 36 V DC
Protection IP20
Current consumption 150 mA at 24 V ÷ 400 mA at 8 V
Storage temperature - 40 °C to + 80 °C
Operating temperature - 30 °C to + 80 °C
The product is fully supported in fw IGS-NT 3.1.1 or higher.
Information about support this module in IGS-NT fw branches and ID-DCU – please read New Feature Lists.
6 back to Extensional modules
8.2.6 IS-AIN8
Description
IS-AIN8 is input extension module equipped with 8 analog inputs. The module can be used for ID, IGS-NT
controller. IS-AIN8 can be configured to:
Resistor two wire input
Resistor three wire input
Current input
Thermocouple input
Voltage input
All inputs can be configured to any logical function or protection. It is possible to connect up to 10 IS-AIN8 (with
IGS-NT) or up to 4 (with ID) external units to one controller. IS-AIN8 is connected to controller CAN1 bus.
This module is compatible with MTU ECU-7 at communication speed 125 kbps when uploaded with firmware
1.2.0 and higher.
To Next Page
Loading...
