ComAp InteliDrive DCU Industrial - Page 280

InteliDrive DCU Industrial 3.4.0 Global Guide
280
Analog output (values) configuration
Any of values from the Source list can be configured to any physical or ECU / J1939 (virtual) Analog output.
Module Number of outputs Note
ID-SCM 3 10V or 20mA or 10V / 10kΩ
IGS-PTM 1 10V or 20mA
I-AOUT8 8 10V or 20mA or pwm
I-IO8/8 2 20mA (10V or pwm not supported by ID-DCU Marine 2.2)
ECU (J1939) 4 (virtual) Format depends on ECU
Analog outputs availability
Analog output configuration
It is possible to convert Source analog value by linear interpolation (conversion). The conversion is given by
definition of two points, Low and High one.
Following is example of transfer characteristics 0 – 100% to 0 – 20mA.
Following are examples of transfer characteristics 0 – 100% to 4 – 20mA. The first case is transfer
characteristics -25 – 100% to 0 – 20mA, it contains the needed conversion to 4 – 20mA.