ComAp InteliDrive DCU Industrial - Page 293

InteliDrive DCU Industrial 3.4.0 Global Guide
293
Available inputs
Analog inputs
8 channels
can be configured as thermocouple sensors only
All inputs can be configured to any logical function or protection.
It is possible to connect up to 10 modules to the InteliGen-NT, InteliSys-NT or InteliMains-NT controllers or up
to 4 modules to the ID-DCU.
Inteli AIN8TC module is connected to controller CAN1 bus.
Supported sensors
Sensors
Thermocpl J [°C] (fix)
Thermocpl K [°C] (fix)
Thermocpl L [°C] (fix)
Thermocpl J [°F] (fix)
Thermocpl K [°F] (fix)
Thermocpl L [°F] (fix)
Thermocpl (nc) J [°C] (fix)
Thermocpl (nc) K [°C] (fix)
Thermocpl (nc) L [°C] (fix)
Thermocpl (nc) J [°F] (fix)
Thermocpl (nc) K [°F] (fix)
Thermocpl (nc) L [°F] (fix)
Note: “nc” means“not cold junction compensation (by external sensor).In this case is used internal temperature
sensor on the PCB