viii
Chapter 4 Remote Console Manager
4.1 RMC Components 4-2
4.2 Terminal Setup 4-3
4.3 Operating Modes 4-4
4.4 Entering the RMC 4-6
4.5 SRM Environment Variables for COM1 4-6
4.6 Status Monitoring 4-7
4.7 Remote Power (On/Off) 4-9
4.8 Remote Halt (In/Out) 4-10
4.9 Configuring Remote Dial-In 4-12
4.10 Configuring Dial-Out Alert 4-14
4.11 Dialing In 4-17
4.12 Resetting the RMC to Factory Defaults 4-18
4.13 Troubleshooting Tips 4-19
4.14 RMC Commands 4-21
4.14.1 clear alert 4-23
4.14.2 clear port 4-23
4.14.3 disable alert 4-23
4.14.4 disable remote 4-24
4.14.5 enable alert 4-24
4.14.6 enable remote 4-25
4.14.7 halt (in/out) 4-26
4.14.8 hangup 4-27
4.14.9 help or ? 4-27
4.14.10 power off 4-27
4.14.11 power on 4-28
4.14.12 quit 4-28
4.14.13 reset 4-29
4.14.14 send alert 4-29
4.14.15 set alert 4-30
4.14.16 set com1_mode 4-31
4.14.17 set dial 4-32
4.14.18 set escape 4-33
4.14.19 set init 4-34
4.14.20 set logout 4-35
4.14.21 set password 4-35
4.14.22 set user 4-36
4.14.23 set wdt 4-36
4.14.24 status 4-36
To Next Page
Loading...
