Compaq Deskpro EN Series User Manual

Compaq Deskpro EN Series of Personal Computers 5-41
9. Align the rear cable clip at the bottom of the drive cage so that it is parallel to the bottom edge
of the drive cage 1.
10. Maintain tension on the cable clip 2 while using a flat-bladed screwdriver to push in on the
tang of the clip from the underside of the drive cage 3. One side of the clip will pull free of the
hole.
11. Continue to maintain tension on the clip while using the screwdriver to push in the other tang
on the clip 4. The clip will pull out of the hole when both tangs have been compressed.
12. Repeat these steps for the front cable clip.
✎
When installing the cable clips it is not necessary to compress the tangs; simply
push the clip end into the hole until it is fully seated.
Removing the Power Switch Cable
To install the power switch assembly with the cable, reverse the removal procedure.
✎
Refer to Section 5.8 for proper power cable connections.
CAUTION:
When returning the drive cage to its normal position use caution to prevent damaging the data
and power cables.

Compaq Deskpro EN Series Specifications

General

Brand	Compaq
Model	Deskpro EN Series
Category	Desktop
Language	English