Compaq Deskpro EN Series - Computer Base Assembly

6-4 Minitower Removal and Replacement
6.4 Computer Base Assembly
6.4.1 Computer Base Removal
1. Turn off the computer before rotating the computer. Failure to do so may cause damage to the
internal components.
2. Lay the computer on its side and remove the four screws that secure the base to the bottom of
the computer.
Removing the Computer Base
To install the computer base, reverse the removal procedure.
✎
The computer may be used without the molded base if vertical clearance is
restricted. Rubber feet are attached to the computer bottom as well as to the
bottom of the computer base for customer convenience.