Compaq Deskpro EN Series User Manual

Compaq Deskpro EN Series of Personal Computers 5-9
5.6.3 Bezel Blank Removal
1. Prepare the computer for disassembly (Section 5.4).
CAUTION:
When the computer is plugged into an AC power source, there is always voltage applied to the
system board. You must disconnect the power cord from the power source before opening the computer
to prevent system board or component damage.
2. Remove the system unit cover (Section 5.6).
3. Lay the system unit cover with its top down on a protected work surface.
4. Squeeze together the sides of the right end of the bezel blank to release the catches.
5. Remove the bezel blank from the front bezel.
Removing the Bezel Blank
To reinstall the bezel blank, reverse the removal procedure.

Compaq Deskpro EN Series Specifications

General

Brand	Compaq
Model	Deskpro EN Series
Category	Desktop
Language	English