F-10 Troubleshooting Without Diagnostics
Network Problems
Some common causes and solutions for network problems are listed in the following table. These
guidelines do not discuss the process of debugging network cabling.
Table F-10
Network Problems
Problem Possible Solution
The Remote Wakeup feature is
not functioning.
The feature is not available when using an AUI network connection;
use an RJ-45 network connection.
Remote Wakeup is not enabled. Use the network control application
to enable Remote Wakeup. Refer to Chapter 2.
Network driver does not detect
network controller.
Network controller is disabled. Run Computer Setup and enable
network controller.
Network status link light does
not turn on or flashes.
No active network is detected. Check cabling and network
equipment for proper connection.
Network connection is not set up properly. Use the network control
application to verify that the device is working properly. Refer to
Chapter 2.
System is configured for AUI connection; link LED does not apply to
AUI connections.
Network driver is not properly loaded. Reinstall network drivers.
Refer to Chapter 2.
System cannot autosense the network. Disable autosensing
capabilities and force the system into the correct operating mode.
Refer to Chapter 2.
Diagnostics reports a failure. The cable is not securely connected or is attached incorrectly.
Ensure that the cable is securely attached to the network connector
and that the other end of the cable is securely attached to the
correct device.
There is a problem with the cable or a device at the other end of the
cable. Ensure that the cable and device at the other end are
operating correctly.
The network controller is defective. Replace the controller or the
system board.
Network controller interrupt with an expansion board. Under the
Computer Setup Advanced menu, change the resource settings for
the board.
Diagnostics passes, but
the computer does not
communicate with the network.
Network drivers are not loaded, or driver parameters do not match
current configuration. Make sure the network drivers are loaded and
that the driver parameters match the configuration of the network
controller.
The network controller is not configured for this computer. In
Windows 95 or Windows NT, select the Network icon at the Control
Panel.
Network controller interrupt with an expansion board. Under the
Computer Setup Advanced menu, change the resource settings for
the board.
continued
To Next Page
Loading...
Need help?
General