6-10 Minitower Removal and Replacement
6.7.3 Bezel Blank Removal
1. Prepare the computer for disassembly (Section 6.3).
CAUTION:
When the computer is plugged into an AC power source, there is always voltage applied to the
system board. You must disconnect the power cord from the power source before opening the computer
to prevent system board or component damage.
2. Remove the access panel (Section 6.6).
3. Remove the front bezel (Section 6.7.1).
4. Lay the front bezel on its front face on a protected work surface to protect it from scratches.
5. Squeeze together the sides of the right end of the bezel blank to release the catches.
6. Remove the bezel blank from the front bezel.
Removing the Bezel Blank
To reinstall the bezel blank, reverse the removal procedure.