Compaq Deskpro EN Series of Personal Computers 7-1
chapter
7
S
ERVICE
N
OTES
CAUTION:
Do not use the desktop version of this computer as a minitower. Doing so will block vent holes
in the side of the cover and can cause serious damage to the computer.
1. When using a 66-MHZ bus processor, you may install either 66- or 100-MHz DIMMs in the
computer. The 100-MHz DIMMs will only run at 66-MHz in this situation.
2. Do not install 66 MHz DIMMs in a computer having a 100-MHz bus processor.
3. Before installing the microprocessor, make sure the release latches are in the locked position.
This will cause the microprocessor to make an audible sound when it is properly seated in the
socket.
4. EDO DIMMs are not supported.
5. The desktop chassis will support a maximum distributed weight of 100 lbs.
6. USB support is available only when using the drivers provided by the device vendor.
7. The computer has the capability for using a Kensington cable lock device. This device is not
available from Compaq.
8. To disable the Spread System function, use the jumper on P108 labeled "Spread Disable."
To Next Page
Loading...
Need help?
General