B-2 Power Cord Set Requirements
Country-Specific Requirements
Power Cord Set Requirements–By Country
Country Accrediting Agency Applicable Note Numbers
Australia EANSW 1
Austria OVE 1
Belgium CEBC 1
Canada CSA 2
Denmark DEMKO 1
Finland SETI 1
France UTE 1
Germany VDE 1
Italy IMQ 1
Japan MITI 3
Norway NEMKO 1
Sweden SEMKO 1
Switzerland SEV 1
United Kingdom BSI 1
United States UL 2
Notes:
1. The flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm
2
conductor size. Power cord set
fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for
evaluation in the country where it will be used.
2. The flexible cord must be Type SJT or equivalent, No. 18 AWG, 3-conductor. The wall plug must be a
two-pole grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A 250V) configuration.
3. The appliance coupler, flexible cord, and wall plug must bear a "T" mark and registration number in
accordance with the Japanese Dentori Law. The flexible cord must be Type VCT or VCTF, 3-conductor,
0.75 mm
2
conductor size. The wall plug must be a two-pole grounding type with a Japanese Industrial
Standard C8303 (15A, 125V) configuration.
To Next Page
Loading...
Need help?
General