Using the scanner, how do I …? 5-8
5.2.4 How do I… Set number of Copies?
You can tell the system to make multiple copies of the original in the scanner. You can set the
system to output between 1 and 50 copies. The default value is 1.
To set the copy Copies value:
On the iJET Panel –
1. Quick Button Setting - Press the Copies button The iJET Panel display will open
the Copies option with the “>” marker on the value level indicating you can immediately
change the Copies option’s value. From here you can skip steps 2 and 3 and go to step 4 to
change the value.
2. Through the Menu – Press the button to enter the main Menu.
Use the arrow up/down buttons
to move through the Menu options until the display
shows Copies.
3. Press
Enter
to move the “>” marker down to indicate you want to change the Copies
value.
4. There are two ways to change the value:
5. Repeated presses to the Copies button will change the Copies value forward in single
steps from 1 to 50..
6. Or…press the arrow up/down buttons
to change the Copies value. With these you
can increase and decrease the value.
7. Press the
Enter
button to accept the selected value. The “>” marker will move up to the
Menu level indicating that the value is set and you can step on through the menu options if
needed. The new Copies value will be applied every time you press the B&W Copy or Color
Copy button until you repeat the steps above to change it.
The ”>” marker is on the Menu level. You can continue
navigating the menu options with the arrow up/down
buttons.
> Copies
3
Copies
> 1
Copies
Copies
>2
Copies
Copies
>3
To Next Page
Loading...
