CPI COTI - Page 118

Secon 6 - Service Keypad Funcons
6.1.5 Key 5 - View Counters
The View Counters or Data Recall buon enables the operator to access the Data Recall
Menu. Entry into this menu allows the operator to view Non-Reseable and Reseable
Sales Data, data relang to Timed Events, Idencaon Numbers of installed components
and (if the feature is enabled) view SureVend™ assisted vend data. The Reseable Sales
Data and SureVend™ Data menus contain an extra sub-menu which allows the operator to
delete the current data from the machines memory. Refer to secon 5.3 Data Recall Menu
for full details relang to this menu and its contents.
6.1.6 Key 6 - Test Vend
The Test Vend buon enables the operator to vend a drink from the machine to ensure
correct operaon aer cleaning or maintenance.
Note: For LINEA standard drinks place cup under dispense nozzles before following the
below sequence. If vending hot water, place cup under hot water spout.
1. Press a drink selecon buon followed by the START buon to begin the vend
sequence.
2. Ensure that the selecon is correct, has not under/overlled the cup and most
importantly, tastes good!
3. Press the Up One Page or Cancel key on the drink selecon keypad to exit from the
Test menu and return to stand-by mode.
6.1.7 Key 7 - Cup Test
This buon enables the operator to test the operaon of the cup drop unit aer relling the
cup stacks. When the buon is pressed the cup drop motor is operated and a cup is ejected
from the cup drop unit. This funcon ensures that the mechanism is working correctly.
6.1.8 Key 8 - Park Head
When this buon is pressed, the dispense head moves to its fully extended posion and
stops. Press the buon again to return the dispense head to its home posion.
6.1.9 Key 9 - Boiler Fill (Espresso Machines)
When this buon is pressed the machine will purge all the water from the pressure water
system by replacing it with fresh water, it will dispense approximately 900ml. This buon
should be used to purge any water le in the system aer the machine has been moved or
shut down for any length of me or if there is an air lock in the closed loop system i.e. aer
an install, a new water lter ed or the machine has been serviced.
Warning: ensure there is a suitable container in posion to catch the water being
dispensed Also be aware this water may be hot.
6.1.10 Key 10 - Machine Cool Down (Espresso Machines)
Machine Cool Down or Boiler Cool Down enables an engineer to work safely on the Espresso
module.
When this buon is pressed the hot water in the pressure system is replaced by 500ml of
cold water. When complete, the message “Machine Cooled” is displayed and all outputs will
108