Step Action
8 Close the lid of the instrument.
Proceed to Section 6.3.7 Start the formulation, on page 101
to start the formulation.
Load syringes and collection tubes
with preheating
CAUTION
Ho
t surface. Avoid direct contact with the heating block and the
top surface of the rotating block during or after heating. Contact
with hot surfaces during or directly after a procedure in which the
heaters are on can cause burns.
If syringe heating is used in the run, the syringes and reagents must be preheated
be
fore the preheated reagents can be loaded.
Before you begin, make sure:
• The reagents are preheated.
• The correct heating inserts are installed, based on the size of the syringes.
• The correct sample arm is installed in the instrument, based on the size of the
collection tubes. To change the sample arm, see Section 5.4 Replace sample arm,
on page 73.
Follow the steps below to preheat the syringes, load the reagents and syringes, and
load the collection tubes.
6 Operation
6
.
3 Run a procedure
6.3.6 Load syringes and collection tubes
NanoAssemblr Ignite and Ignite+ Operating Instructions NIN1134 AA 97
To Next Page
Loading...
