D-Link DGS-3120-48PC - Page 151

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
147
DGS-3120-24TC:admin#config ipif System ipaddress 192.168.69.123/24 vlan default
Command: config ipif System ipaddress 192.168.69.123/24 vlan default
Success.
DGS-3120-24TC:admin#
12-15 delete ipif (EI Mode Only)
Description
This command is used to delete an IP interface.
Format
delete ipif [<ipif_name 12> {ipv6address <ipv6networkaddr>} | all]
Parameters
ipif - Specify the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
ipv6address – (Optional) Specify the IPv6 network address. The address should specify a host
address and length of network prefix. There can be multiple V6 addresses defined on an
interface.
<ipv6networkaddr> - Enter the IPv6 address used here.
all
– Specify that all the IP interfaces will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP interface:
DGS-3120-24TC:admin#delete ipif newone
Command: delete ipif newone
Success.
DGS-3120-24TC:admin#
12-16 enable ipif (EI Mode Only)
Description
This commands is used to enable the IP interface.
Format
enable ipif [<ipif_name 12> | all]