D-Link DGS-3120-48PC - Chapter 87 Voice VLAN Command List

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
746
Chapter 87 Voice VLAN Command List
enable voice_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
disable voice_vlan
config voice_vlan priority <int 0-7>
config voice_vlan oui [add | delete] <macaddr> <macmask> {description <desc 32>}
config voice_vlan ports [<portlist> | all] [state [enable | disable] | mode [auto {[tag
|untag]}|manual]]
config voice_vlan aging_time <min 1-65535>
config voice_vlan log state [enable | disable]
show voice_vlan
show voice_vlan oui
show voice_vlan ports {<portlist>}
show voice_vlan voice_device {ports <portlist>}
show voice_vlan lldp_med voice_device
87-1 enable voice_vlan
Description
This command is used to enable the global voice VLAN function on a switch. To enable the voice
VLAN, the voice VLAN must be also assigned .At the same time, the VLAN must be an existing
static 802.1Q VLAN.
To change the voice VLAN, the user must disable the voice VLAN function, and re-issue this
command.
By default, the global voice VLAN state is disabled.
Format
enable voice_vlan [<vlan_name 32> | vlanid <vlanid 1-4094>]
Parameters
<vlan_name 32> - Enter the name of the voice VLAN here. This name can be up to 32
characters long.
vlanid - Specify the VLAN ID of the voice VLAN.
<vlanid 1-4094> - Enter the voice VLAN ID here. This value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable a voice VLAN with name “v2”: