D-Link DGS-3120-48PC - Chapter 15 Command Logging Command List

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
160
Chapter 15 Command Logging
Command List
enable command logging
disable command logging
show command logging
15-1 enable command logging
Description
This command is used to enable the command logging function.
Note: When the Switch is under booting procedure, all configuration command should not be
logged. When the user under AAA authentication, the user name should not changed if user
uses “enable admin” command to replace its privilege.
Format
enable command logging
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the command logging function:
DGS-3120-24TC:admin# enable command logging
Command: enable command logging
Success.
DGS-3120-24TC:admin#
15-2 disable command logging
Description
This command is used to disable the command logging function.
Format
disable command logging