D-Link DGS-3120-48PC - Show Rspan

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
600
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure an RSPAN source entry without source target port:
DGS-3120-24TC:admin# config rspan vlan vlan_name VLAN2 source add ports 1:2-1:5
rx
Command:config rspan vlan vlan_name VLAN2 source add ports 1:2-1:5 rx
Success.
DGS-3120-24TC:admin#
To configure an RSPAN source entry for per flow RSPAN, without any source ports:
DGS-3120-24TC:admin# config rspan vlan vlan_id 2 source
Command:config rspan vlan vlan_id 2 source
Success.
DGS-3120-24TC:admin#
To add redirect ports for special RSPAN VLAN on intermediate or destination switch:
DGS-3120-24TC:admin# config rspan vlan vlan_name vlan2 redirect add ports
1:18-1:19
Command: config rspan vlan vlan_name vlan2 redirect add ports 1:18-1:19
Success.
DGS-3120-24TC:admin# config rspan vlan vlan_id 2 redirect add ports 1:18-1:19
Command: config rspan vlan vlan_id 2 redirect add ports 1:18-1:19
Success.
DGS-3120-24TC:admin#
63-6 show rspan
Description
This command is used to display the RSPAN configuration.
Format
show rspan {[vlan_name <vlan_name> | vlan_id <vlanid 1-4094>]}
Parameters
vlan_name - (Optional) Specify the RSPAN VLAN by VLAN name