D-Link DGS-3120-48PC - Chapter 22 Debug Software Command List

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
221
Chapter 22 Debug Software Command
List
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show jwac auth_info
debug dhcpv6_client state enable (EI Mode Only)
debug dhcpv6_client state disable (EI Mode Only)
debug dhcpv6_client output [buffer | console] (EI Mode Only)
debug dhcpv6_client packet [all | receiving | sending] state [enable | disable] (EI Mode Only)
debug dhcpv6_relay state enable (EI Mode Only)
debug dhcpv6_relay state disable (EI Mode Only)
debug dhcpv6_relay output [buffer | console] (EI Mode Only)
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable] (EI Mode Only)
debug dhcpv6_relay hop_count state [enable | disable] (EI Mode Only)
22-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specify the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters
long.
Restrictions
Only Administrator-level users can issue this command.
Example
To dump the error log: