D-Link DGS-3120-48PC - Debug Config State

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
225
Restrictions
Only Administrator-level users can issue this command.
Example
To set the Switch to not need a reboot when a fatal error occurs:
DGS-3120-24TC:admin# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DGS-3120-24TC:admin#
22-5 debug config state
Description
This command is used to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrator-level users can issue this command.
Example
To set the debug state to disabled:
DGS-3120-24TC:admin# debug config state disable
Command: debug config state disable
Success.
DGS-3120-24TC:admin#
22-6 debug show jwac auth_info
Description
This command is used to show debug information of JWAC.