D-Link DGS-3120-48PC - Show Poe System; Show Poe Ports

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
553
57-3 show poe system
Description
This command is used to display the setting and actual values of the whole PoE system.
Format
show poe system {units <unitlist>}
Parameters
units - (Optional) Specified units that will be displayed.
<unitlist> - Enter the unit list that will be displayed here.
If no parameter specified, the system will display the status of all supported poe units in the
systems.
Restrictions
None.
Example
To display PoE system:
DGS-3120-24PC:admin#show poe system units 1
Command: show poe system units 1
Unit: 1 PoE System Information
---------------------------------------------------
Power Limit : 760(Watts)
Power Consumption : 0(Watts)
Power Remained : 371(Watts)
Power Disconnection Method : Deny Next Port
Detection Legacy PD : Disabled
If Power Disconnection Method is set to deny next port, then the system can not
utilize out of its maximum power capacity. The maximum unused watt is 19W.
DGS-3120-24PC:admin#
57-4 show poe ports
Description
This command is used to display the setting and actual values of PoE port.