D-Link DGS-3120-48PC - Show Ipfdb

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
738
Parameters
<network_address> - (Optional) Specify the destination network address of the route to be
displayed. (EI Mode Only)
<ipaddr> - (Optional) Specify the destination IP address of the route to be displayed. The longest
prefix matched route will be displayed. (EI Mode Only)
static - (Optional) Specify to display only static routes. One static route may be active or inactive.
hardware - (Optional) Specify to display only the routes that have been written into the chip. (EI
Mode Only)
Restrictions
None.
Example
To display the contents of the IP routing table:
DGS-3120-24TC:admin# show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Cost Protocol
------------------ --------------- ------------ -------- --------
10.1.1.0/24 0.0.0.0 System 1 Local
192.168.1.0/24 0.0.0.0 ip1 1 Local
Total Entries : 2
DGS-3120-24TC:admin#
85-4 show ipfdb
Description
This command is used to display the current network address forwarding database.
Format
show ipfdb {[ip_address <ipaddr> | interface <ipif_name 12> | port <port>]}
Parameters
ip_address - (Optional) Displays the specified host IP address.
<ipaddr> - Enter the IP address used here.
interface - (Optional) Specify a IP interface.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
port - (Optional) Specify a port.
<port> - Enter the port number here.