D-Link DGS-3120-48PC - Config Jwac Virtual_Ip [<Ipaddr> | <Ipv6 Addr>] {Url [<String 128> | Clear]

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
382
Example
To set the quarantine server error timeout:
DGS-3120-24TC:admin#config jwac quarantine_server_error_timeout 60
Command: config jwac quarantine_server_error_timeout 60
Success.
DGS-3120-24TC:admin#
37-15 config jwac virtual_ip
Description
This command is used to configure JWAC virtual IP addresses used to accept authentication
requests from an unauthenticated host. The virtual IP of JWAC is used to accept authentication
request from unauthenticated host. Only requests sent to this IP will get correct responses. This IP
does not respond to ARP requests or ICMP packets.
Format
config jwac virtual_ip [<ipaddr> | <ipv6addr>] {url [<string 128> | clear]}
Parameters
<ipaddr> - Specify the IP address of the virtual IP.
<ipv6addr> - Specify the Ipv6 address of the virtual IP. (EI Mode Only)
url - (Optional) Specify the URL of the virtual IP.
<string 128> - Specify the URL of the virtual IP.
clear - Clear the URL of the virtual IP.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a JWAC virtual IP address of 1.1.1.1 to accept authentication requests from an
unauthenticated host:
DGS-3120-24TC:admin# config jwac virtual_ip 1.1.1.1
Command: config jwac virtual_ip 1.1.1.1
Success.
DGS-3120-24TC:admin#
37-16 config jwac update_server
Description
This command is used to add or delete a server network address to which the traffic from an
unauthenticated client host will not be blocked by the JWAC Switch. Any servers running ActiveX