D-Link DGS-3120-48PC - Chapter 29 Filter Command List

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
275
Chapter 29 Filter Command List
config filter netbios [<portlist> | all] state [enable | disable]
show filter netbios
config filter extensive_netbios [<portlist> | all] state [enable | disable]
show filter extensive_netbios
29-1 config filter netbios
Description
This command is used to configure the Switch to deny the NETBIOS packets on specific ports.
Format
config filter netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specify the list of ports used.
all - Specify that all the ports will be used for the configuration.
state- Specify the state of the filter to block the NETBIOS packet.
enable - Specify that the state will be enabled.
disable - Specify that the state will be disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure filter netbios state:
DGS-3120-24TC:admin# config filter netbios 1-10 state enable
Command: config filter netbios 1-10 state enable
Success.
DGS-3120-24TC:admin#
29-2 show filter netbios
Description
This command is used to display the NETBIOS filter state on the Switch.
Format
show filter netbios