D-Link DGS-3120-48PC - Enable Snmp Traps; Disable Snmp Traps

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
665
DGS-3120-24TC:admin# config snmp system_contact "MIS Department II"
Command: config snmp system_contact "MIS Department II"
Success.
DGS-3120-24TC:admin#
72-24 enable snmp traps
Description
This command is used to enable SNMP trap support.
Format
enable snmp traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable SNMP trap support:
DGS-3120-24TC:admin# enable snmp traps
Command: enable snmp traps
Success.
DGS-3120-24TC:admin#
72-25 disable snmp traps
Description
This command is used to disable SNMP trap support on the Switch.
Format
disable snmp traps
Parameters
None.