D-Link DGS-3120-48PC - Chapter 73 Single IP Management Command List

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
673
Chapter 73 Single IP Management
Command List
enable sim
disable sim
show sim {[candidates {<candidate_id 1-100>} | members{<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
reconfig {member_id <value 1-32> | exit}
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
config sim [{[commander {group_name <groupname 64>} | candidate] | dp_interval <sec 30-90> |
hold_time <sec 100-255>}]
download sim_ms [firmware_from_tftp | configuration_from_tftp] <ipaddr> <path_filename>
[members <mslist 1-32> | all]
upload sim_ms [configuration_to_tftp | log_to_tftp] <ipaddr> <path_filename> [members <mslist>
| all]
73-1 enable sim
Description
This command is used to configure the single IP management on the Switch as enabled.
Format
enable sim
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable SIM:
DGS-3120-24TC:admin# enable sim
Command: enable sim
Success.
DGS-3120-24TC:admin#