D-Link DGS-3120-48PC - Config Authentication Ports

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
164
Parameters
vlan - Assigned a VLAN as guest VLAN. The VLAN must be an existed static VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - Assigned a VLAN as guest VLAN. The VLAN must be an existed static VLAN.
<vlanid 1-4094> - Enter the VLAN ID here. This ID must be between 1 and 4094.
add - Specify to add port list to the guest VLAN.
delete - Specify to delete port list from the guest VLAN.
ports - Specify the configured port(s).
<portlist> - Enter the list of ports to be configured here.
all - Specify all ports on the Switch.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure security port(s) as specified guest VLAN member:
DGS-3120-24TC:admin# config authentication guest_vlan vlan gv add ports all
Command: config authentication guest_vlan vlan gv add ports all
Success.
DGS-3120-24TC:admin#
16-4 config authentication ports
Description
This command is used to configure security port(s).
Format
config authentication ports [<portlist> | all] {auth_mode [port_based | host_based {vlanid
<vid_list> state [enable | disable]}] | multi_authen_methods [none | any | dot1x_impb |
impb_jwac | impb_wac | mac_impb]}
Parameters
<portlist> - Enter the list of ports to be configured here.
all - Specify all ports on the Switch.
auth_mode - (Optional) Specify the authentication mode used.
port_based - If one of the attached hosts passes the authentication, all hosts on the same
port will be granted to access network. If the user fails to authorize, this port will keep trying
the next authentication
host_based - Every user can be authenticated individually. v2.01 and later, can authenticate
client on specific authentication VLAN(s) only for WAC.
vlanid - (Optional) Specific authentication VLAN(s). This is useful when different VLANs on
the Switch have different authentication requirements.
<vidlist> - Enter the VLAN ID list here.
state - (Optional) Specify the VID list's authentication state.
enable - Assign the specified VID list as authentication VLAN(s).
disable - Remove the specified VID list from authentication VLAN(s). If "vlanid" is not