authorization autoconfig bandwidth_control boot_file
bpdu_protection cfm command command_history
config cpu current_config device_status
dhcp_local_relay dhcp_relay dot1v_protocol_group
dscp egress_access_profile egress_flow_meter
environment erps error fdb
filter flow_meter gratuitous_arp greeting_message
gvrp hol_prevention igmp_snooping ipfdb
ipif ipif_ipv6_link_local_auto iproute
ipv6 ipv6route jumbo_frame lacp_port
limited_multicast_addr link_aggregation lldp
log log_save_timing log_software_module
loopdetect mac_based_access_control
mac_based_access_control_local mac_based_vlan mac_notification
max_mcast_group mcast_filter_profile mirror
mld_snooping multicast multicast_fdb nlb
packet password_recovery per_queue poe
port port_group port_security
port_security_entry port_vlan ports
power_saving private_vlan pvid qinq
radius rmon router_ports rspan
safeguard_engine scheduling scheduling_mechanism
serial_port session sflow sim
snmp sntp ssh ssl
stack_device stack_information stacking_mode
storage_media_info stp switch
syslog system_severity tech_support terminal
time time_range traffic
traffic_segmentation trap trusted_host
utilization vlan vlan_translation vlan_trunk
voice_vlan wac
DGS-3120-24TC:admin#
In the above example, all of the possible next parameters for the show command are displayed. At
the next command prompt, the up arrow was used to re-enter the show command, followed by the
account parameter. The CLI then displays the user accounts configured on the Switch.
1-3 Command Syntax Symbols
For example, in the syntax
create ipif <ipif_name 12> {<network_address>} <vlan_name 32>
{secondary | state [enable | disable] | proxy_arp [enable | disable]
{local [enable | disable]}}
users must supply an IP interface name for <ipif_name 12> ,a VLAN
name for <vlan_name 32> and an address for <network_address>
To Next Page
Loading...
