D-Link DGS-3120-48PC - Show Snmp Traps

xStack
®
DGS-3120 Series Managed Switch CLI Reference Guide
670
Parameters
enable - Enable the trap of the warmstart event. The default state is enabled.
disable - Disable the trap of the warmstart event.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the trap state for warmstart event:
DGS-3120-24TC:admin# config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable
Success.
DGS-3120-24TC:admin#
72-33 show snmp traps
Description
This command is used to display the snmp trap sending status.
Format
show snmp traps {linkchange_traps {ports <portlist>}}
Parameters
linkchange_traps - (Optional) Specify that the SNMP trap sending status will be displayed.
ports - (Optional) Specify the ports for the display.
<portlist> - Enter the list of ports used for the display here.
Restrictions
None.
Example